Attaching your warp bouts to your back beam!

Hi all

At last I've time to post the image of how I tie my warp bouts to my back beam.

First of all, those of you who asked for information on how your smooth back beam could be made to take the ties. Well, here is how it's done on my loom, a Louet Octado. You see the stainless steel rod that is loosely attached to my back beam by Texolv cord. The cord is cut into small sections which are screwed to the back beam and the rod is then threaded through these tapes across the back beam.

You will notice that I've attached a very long loop of strong yarn to the rod opposite each section of the beam. All I did was cut a length of thread twice the length from the bar on the back beam to the back of the heddles. I tied it the ends together, threaded each one over the rod and put the loop end through the knot end to secure it to the rod.

Now I make my bouts and secure the cross with bag twist ties and thread the long loop through the end of the bout near the cross. Here you can see the loop through the bout.



I now let the bout drop, but keep hold of the loop and, putting my hand through the loop, I pull the the bout right through the loop. The bout is now trapped in the loop and you can wind it onto the beam as you can see in my post on warping.








This image shows the bout trapped at the end of the loop, just before I put the "cross keeper" round the cross and spread it on the mini raddle.

Sectional Warping

Hi all,

At the end of last year someone on the Weave Tech Group was asking about sectional warping and I said I didn't use a bobbin rack, but made small warps on my warping mill. I thought it might be a good idea to show everyone how I do it.

First of all I make small 2" warps on my warping mill which a tie with freezer bag ties to secure the cross and keep the loop open at the beginning.

Bag ties are easy to attach and remove and are re-usable. I cut some of them into two before I start to make the warp as they can be too big.

I then have my loops ready at the back of the loom and attach one to the sectional warp beam and the other end to loop at the end of the warp near the cross. If your not sure how to do this post a comment and I will show you have it's done in another post.



Now I put this little devise into the cross and weight the warp at the front of the loom with a loop of loom cord, a butchers hook and a bottle of wash detergent!

Once the section of warp has been weighted I spread it over a small raddle, that came with my Louet Octado, which is secured to the back beam.

Move the cross to the front of the loom, near the cord and weight, and wind the warp onto the sectional beam until the cross is next to the raddle again. Continue winding the warp and moving the cross until the section is wound onto the beam.

On the left you will see the front cloth beam of my loom with all that is left of the warp where it is being weighted. Once the cord that is attached to the weight gets to this point, I remove the weight and cord then loop an elastic band round the warp end in it's place.

All I do now is wind this last section onto the sectional warp beam and loop the elastic band round the section separator next to the previously wound section.

I do hope this has been of help.